The safe use of the multi nozzle soft flow dyeing machine, during the operation, when we found that the locking ring was not locked, before the in-and-out device and its other fastening screws were not tightened, we actually did not The separator can be started, and if the drum does not completely stop, it is impossible to loosen any fasteners of the machine; when it has abnormal noise and abnormal vibration, it should stop immediately and To turn off the power.
When the multi nozzle soft flow dyeing machine is operated, it is actually the main part that does not use flame heating or repair welding drum, especially for the drum body or the drum cover and the lock ring. When the drum needs to be repaired, it is actually necessary to contact our factory immediately. Then, in fact, it is necessary to ask the professional to carry out maintenance. In this way, it is actually to avoid a series of safety accidents. .
If the multi nozzle soft flow dyeing machine is operated, the drum parts cannot be exchanged with other machine drum parts. Even if the parts of the same type of machine are not interchangeable, it will be directly A failure has occurred.
When the multi nozzle soft flow dyeing machine is operated, it should be locked at the "0" alignment. When its lock ring and "0" assembly mark, it will actually pass the drum body directly. When the corresponding mark is above 25 degrees, it is actually prohibited from being used directly; in addition, the dyeing machine cannot work under overspeed and under overload.
https://www.tonghuadyeingmachine.com
